W3540 on Vapochiller 24/7

[Underground]

here is a old buildlog from me with a vapochiller 24/7 :

the phase-changer is modded with a better evap, heatexchanger etc,
suction line is also longer.

http://i32.tinypic.com/296dicg.jpg
http://i28.tinypic.com/21n2ydi.jpg

socket isolation kit lga1366 :

http://i26.tinypic.com/15whtzs.jpg

mounting the evap head

http://i31.tinypic.com/1fcjtk.jpg

some extra isolation , because this will run 24/7 :

http://i25.tinypic.com/rs9e8m.jpg

a little bit dialectric grease on petro base

http://i25.tinypic.com/2nsq881.jpg
http://i27.tinypic.com/iofais.jpg
http://i28.tinypic.com/2sald7d.jpg

mounting on the motherboard :

http://i28.tinypic.com/2hdnndg.jpg
http://i32.tinypic.com/x1k0o8.jpg
http://i32.tinypic.com/2r720cl.jpg

the new danfoss comp good visible :

http://i31.tinypic.com/2enlvye.jpg

and this is the outside :

http://i31.tinypic.com/30u3jid.jpg

some overclock results of the W3540 :

http://i30.tinypic.com/1611a2q.jpg
http://i32.tinypic.com/358uctu.jpg
http://i26.tinypic.com/333k8b5.jpg
http://i28.tinypic.com/2wfn1v9.jpg

[KaptCrunch]

chiller you be better off using eraser clay around socket and use the dielectic grease for bottom side of cpu pins an socket

[Underground]

eraser clay i only use with Dice and ln².

for tec and phase-change i use socket isolation kits, easier in use and work to same, but a little more expensive then the Eraser clay.

For going subzero there is only 1 rule :

air tight closed, no air, no condensation

[Overclocking101]

amen. the more neoprene and dielectric grease the better. it would be a shame to under insolate and kill that setup

[Underground]

indeed, can never be shure enough